Coolant Drain And Fill(Flush) 2013 Honda Accord(9th Gen)

In this video I show you how to drain and fill your coolant on a 2013 Accord. To flush it, you keep doing this procedure about 2-3 times.

PROCEDURE:
1. Put bucket under car
2. Locate coolant knob and turn counter clockwise to let coolant out
3. Open up radiator cap and empty coolant reservoir
4. After the flow gets to a dropping point take out the knob to let all fluid out
5. Add coolant
6. Locate coolant line(big hose from radiator to engine)
7. Squeeze the hose from a couple different points slowly(should make coolant go down as it is removing air)
8. Add more coolant as needed
9. Go to car. Put in ACC Mode. Turn heat to High, start car, let it sit for 3-4 cycles. You can slowly rev it a couple times to 2k.
10. Add coolant as needed
11. Let car reach operating temperature
12. Keep checking coolant level later in day when car is cold
13. You are done!

If you have any questions let me know!

Things used:
Honda Type 2 Extended Life Coolant(2 Gallons, only used like 1 and a half)

Make sure to recycle your old coolant!




Disclaimer:
This video is for educational and recreational purposes only. I am not liable for any damages occurred. Perform at your own risk.

coolant,change,honda,accord,2013,2014,2015,2016,2017,13,14,15,16,17,9th,generation,gen,antifreeze,flush,drain,and,fill,type 2,100k,service,diy,